LigoPTP: CLI (Command Line Interface)

Command Line Interface Management

The Command Line Interface, or CLI, software is a configuration shell for LigoPTP devices. CLI is an alternative way of configuring the device. It is not intended to be the main device management method. Using CLI, the operator can test the authentication parameters, change the administrator’s password, reboot the device, reset the device to its default settings, see the device configuration, or view the device status.

CLI Access

Use the SSH client application (e.g. Putty) to access the CLI of the WILI-S-based device.

Make sure that the SSH server is properly configured.

Login

Enter the administrator login information as displayed in the command prompt.

Default administrator login information:

  • User Name: admin
  • Password: admin01
Passwords will not appear on the screen for safety purposes.

After a successful login, enter the help command to get the list of available CLI commands:

help

ligoCLI

List off all CLI commands:

logout
reboot
reset-to-defaults
ping <ip>
telnet <ip>
show config
save config
show gateway
set gateway <gateway>
show software version
shell
linktest [frames <packet count>] [pkt-size <packet size>] [sessions <sessiont>] [peer <peer number>] [ip <remote IP>]
show interface list
show interface <interface> mac
show interface <interface> ip
set interface <interface> ip <ip/subnet mask>
show interface <interface> wireless-mode
set interface <interface> wireless-mode <ap, station>
show interface <interface> ssid
set interface <interface> ssid <ssid>
show interface <interface> ssid-broadcast
set interface <interface> ssid-broadcast
no interface <interface> ssid-broadcast
show interface <interface> security
set interface <interface> security <open, wpa2-psk>
        wpa2-psk encr aes pass <pass>
show interface <interface> channel
set interface <interface> channel <channel>
set interface <interface> channel-auto <channel,channel,...>
set interface <interface> txpower <txpower>
set interface <interface> up
set interface <interface> down
show interface <interface> peers
set interface <interface> vlan <vlan id>
no interface <interface> vlan <vlan id>
Examples of how to use CLI commands:

To change the wireless security setting, type the following command and press the Enter key:

set interface ra0 security open

To view what channels the radio is working on, type the following command and press Enter:

show interface ra0 channel

ligowaveinterfacechan

To check the current radio SSID, type the following command and press Enter:

show interface ra0 ssid

ligoshowinterface

Type logout to leave the CLI mode:

logout